Faster Charging, Done Properly
The standard 120-volt cord that comes with an electric vehicle trickles in only a few miles of range per hour — fine in a pinch, frustrating as a daily routine. A Level 2 charger runs on a dedicated 240-volt circuit and replenishes most EVs overnight, so you leave every morning with a full battery. But adding one isn’t just mounting a box on the garage wall; it takes a correctly sized circuit, a load calculation, and often a permit.
Sky Source Electric has wired home charging across San Diego County, and as a licensed C-10 contractor (CSLB #1075064), we handle EV charger installation end to end: verifying your panel has the capacity, running a dedicated circuit, mounting a hardwired unit or a NEMA 14-50 outlet, and pulling the permit. We work with all major brands and connector standards, and we route conduit cleanly so the finished install looks as good as it performs. If your panel is full, we’ll tell you honestly and lay out your options.
Why Install Level 2 Home Charging
Full by Morning
Overnight charging means you rarely think about public stations again.
Any EV Brand
We install units for every make and connector standard on the road.
Proper Load Calc
We confirm your panel can handle the charger before we wire it.
Pairs With Solar
Charge on your own solar power for the lowest cost per mile.
From Panel to Plug-In
1. Assess Your Panel
We run a load calculation to confirm capacity and pick the best charger location.
2. Plan the Route
We map a clean conduit path and quote the circuit, unit, and permit up front.
3. Install & Permit
We run the dedicated circuit, mount the charger, and pull the required permit.
4. Test & Show You
We verify a full-speed charge and walk you through using your new setup.
Complete EV Charging Installs
- ✔ Level 2 chargers for all EV brands
- ✔ Hardwired units or NEMA 14-50 outlets
- ✔ Dedicated 240-volt circuits with load calculations
- ✔ Clean conduit routing, indoor or outdoor
- ✔ Panel capacity checks and upgrades when needed
EV Charging Across the County
EV Charger Installation Questions
How fast will a Level 2 charger charge my EV?
Most Level 2 chargers add roughly 20 to 40 miles of range per hour, depending on your vehicle and the circuit size. For nearly every driver, that means a full battery overnight from a home outlet.
Do I need a permit for an EV charger?
In most San Diego jurisdictions, yes. A hardwired charger or a new 240-volt circuit typically requires a permit and inspection, both of which we handle as part of the job.
What if my electrical panel is full?
It happens often on older homes. We’ll run a load calculation and, if needed, recommend a panel upgrade to make room for the charger safely.
Can I charge with my solar system?
Absolutely — and it’s the cheapest way to drive. We can coordinate your charger with a solar installation so you fuel up on your own power.
Power Your Drive
Ready to Charge at Home?
Get a clean, permitted Level 2 charger install sized to your home — from a licensed local team.